Saf-holland XL-FW353 FLEETMASTER CUPLING Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la voiture Saf-holland XL-FW353 FLEETMASTER CUPLING. SAF-HOLLAND XL-FW353 FLEETMASTER CUPLING User Manual Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
COUPLING PROCEDURES:
1. Inspect the fifth wheel mounting.
• Tighten loose fasteners
• Replace missing fasteners
• Repair/replace cracked components
NOTE: If you have a sliding fifth wheel, make sure
both plungers are fully engaged (locked).
(See Page 4, Figure 4B)
2. Make sure coupling area is flat, level and clear
of persons and obstacles.
3. Lubricate the fifth wheel-to-trailer contact
surface with grease. Tilt the ramps down.
XL-FW353
OK
TILT
DOWNWARD
4. Make sure the locks are open. To open locks,
slide the handle forward and pull it out to the
maximum extension. The lock will swing to
the open position.
5. Center fifth wheel with kingpin.
6. Back tractor close to trailer and STOP.
LOCK OPEN
POSITION
ACTUATING FINGER
PULL OUT
ALL THE WAY
SLIDE
FORWARD
TO OPEN LOCK
TRAILER
(TOP)
KINGPIN
1
FLEETMASTER
OPERATING
INSTRUCTIONS
You must read and understand the following instructions before operating your fifth wheel. Failure to
follow all of the important maintenance procedures contained in these instructions may result in a
hazardous condition or cause a hazardous condition to develop.
These instructions apply to the proper operation of your fifth wheel only. There are other important
checks, inspections and procedures not listed here that are necessary, prudent, and/or required by law.
WARNING
Vue de la page 0
1 2 3 4

Résumé du contenu

Page 1 - FLEETMASTER

COUPLING PROCEDURES:1. Inspect the fifth wheel mounting.• Tighten loose fasteners• Replace missing fasteners• Repair/replace cracked componentsNOTE:

Page 2 - PULL TEST

7. Chock trailer wheels.8. Connect brake linesand light cord.9. Support slack in lines to prevent interference.10. Set trailer brakes.11. Adjust trail

Page 3 - UNCOUPLING PROCEDURES:

15. Retract landing gear until pads come off theground.16. Switch to high gear, fully retract and securecrank handle.17. Re-check brake lines and ligh

Page 4 - ADJUSTMENT:

5. Slowly drive the tractor forward or backward toposition the fifth wheel.6. Re-engage the slide locking plungers. Verifythat both plungers have full

Commentaires sur ces manuels

Pas de commentaire