Saf-holland XL-AS11011OM CBX40/CB-4000 Slider Suspension Syste Manuel d'utilisateur télécharger pdf (Page 19)

XL-AS11011OM-en-US Rev F · 2014-06-13 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, SAF,

and logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.

b. Lift and push the pull arm handle from the disengaged

position (Notch 2 - Figure 27) to the engaged

position (Notch 1 - Figure 28).

NOTE: If your slider is equipped with an air release pin

mechanism, push the air release control valve

knob to engage the lock pins.

8. Visually check that the lock pins are fully engaged and

extend through the holes in the upper rail (Figure 29).

An unsecured slider box can cause loss

of vehicle control which, if not avoided,

could result in death, serious injury or

property damage.

9. Visually check that the manual stop bar is properly installed

directly behind slide box (Figure 29).

Failure to properly install or position the

manual stop bar could result in improper

trailer load distribution which, if not

avoided, could result in damage to the

suspension or trailer parts.

Operation Instructions

PULL ARM

HANDLE

DISENGAGED POSITION

NOTCH 1

NOTCH 2

ENGAGED POSITION

NOTCH 1

NOTCH 2

MANUAL

STOP BAR

LOCK PINS

ENGAGED

IN SLIDER RAIL

Figure 28

Figure 29

Figure 27

PULL ARM

HANDLE

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Saf-holland XL-AS11011OM CBX40/CB-4000 Slider Suspension Syste Manuel d'utilisateur Page 19