Saf-holland XL-AS11011OM CBX40/CB-4000 Slider Suspension Syste Manuel d'utilisateur télécharger pdf (Page 14)

XL-AS11011OM-en-US Rev F · 2014-06-13 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, SAF,

and logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.

Installation Instructions

Figure 17

Figure 18

Figure 16

12. Slider Assembly Installation

1. Remove the hold down clips on all four (4) corners of

the slider.

2. Locate the slider between the body rails of the trailer and

engage the lock pins. Refer to the slider re-positioning

operating instructions in Section 16 of this manual.

3. Once the slider is correctly positioned, re-install the hold

down clips to the slider and body rails, and torque all

IPMEEPXODMJQOVUTUPGUMCT/tN

4. Ensure the linkage assembled to the height control valve (HCV)

and suspension is of the appropriate height (Figure 16).

IMPORTANT: A 15" linkage is used for ride heights of

15.5"-17". A 16" linkage is required for

18" ride heights (Figure 16).

Failure to match the linkage length to the

design ride height could result in improper

suspension height which, if not avoided,

could result in damage to trailer components.

5. Install service and emergency lines to the slider and

allow the suspension to air up.

6. Measure the ride height of the suspension (Figure 17)

with a tape measure.

7. Compare the measured suspension ride height value to

the appropriate value (Table 1). Ensure your measured

ride height value is within ± 1/4" (6 mm).

IMPORTANT: If your measured ride height value is NOT

within ± 1/4"(6 mm); use the table to verify

the linkage length (Table 2 and Figure 16),

and the hole location where the top mounting

stud of the height control valve (HCV) is

bolted to the mounting bracket (Figure 18).

8. Visually check all air control system fittings for air leaks

by applying a soapy water solution and checking for

bubbles at all air connections and fittings.

LOWER LINKAGE

CONNECTION

15" LINKAGE LENGTH

18" RIDE HEIGHT

REQUIRES 16" LINKAGE

HEIGHT CONTROL

VALVE ARM

“A”

RIDE

HEIGHT

MODEL “A” RIDE HEIGHT

CBX40 / CB-4000 - 15.5 15.5"

CBX40 / CB-4000 - 16 16"

CBX40 / CB-4000 - 16.5 16.5"

CBX40 / CB-4000 - 17 17"

CBX40 / CB-4000 - 18 18"

Table 1

RIDE HEIGHT HOLE LOCATION LINKAGE LENGTH

15.5" TOP HOLE 15"

16" 2ND HOLE 15"

16.5" 3RD HOLE 15"

17" 4TH HOLE 15"

18" 4TH HOLE 16"

Table 2

HEIGHT CONTROL VALVE

MOUNTING BRACKET

TOP HOLE

2ND HOLE

3RD HOLE

4TH HOLE

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Saf-holland XL-AS11011OM CBX40/CB-4000 Slider Suspension Syste Manuel d'utilisateur Page 14

Commentaires sur ces manuels