Saf-holland XL-AS11011OM CBX40/CB-4000 Slider Suspension Syste Manuel d'utilisateur télécharger pdf (Page 18)

XL-AS11011OM-en-US Rev F · 2014-06-13 · Amendments and Errors Reserved · © SAF-HOLLAND, Inc., SAF-HOLLAND, HOLLAND, SAF,

and logos are trademarks of SAF-HOLLAND S.A., SAF-HOLLAND GmbH, and SAF-HOLLAND, Inc.

PULL ARM

HANDLE

LOCK PINS

ENGAGED

ENGAGED POSITION

NOTCH 1

NOTCH 2

Operation Instructions

Figure 25

Figure 26

Figure 24

16. Slider Repositioning Instructions

1. With the vehicle on a level surface, set the tractor and

trailer brakes and locate the slider QWIK RELEASE

pull

arm handle (Figure 24), or air release control valve.

2. To reposition the slider, remove the manual stop bar

and relocate to desired location – rearward of slide box

if moving rearward, or forward of slide box if moving

forward (Figure 24).

If repositioning the slider forward, remove the manual

stop bar and relocate directly behind slide box after the

slider is moved to final position.

3. Lift and pull the QWIK RELEASE

pull arm handle from

the engaged position (Notch 1 - Figure 25) to the

disengaged position (Notch 2 - Figure 26).

NOTE: If your slider is equipped with an air release pin

mechanism, pull the air release control valve knob

to disengage the lock pins.

4. Visually check to ensure the lock pins are in the disengaged

position, and that the QWIK RELEASE

pull arm handle is

locked (Notch 2 - Figure 26).

When lock pins have properly disengaged, proceed to

Step 6.

If lock pins fail to disengage, proceed to Step 5.

5. If the QWIK RELEASE

pull handle is in the notch 2

position but the lock pins fail to retract and are still

in the engaged position, the QWIK RELEASE

pull

arm is in an armed, ready to unlock position.

NOTE: The QWIK RELEASE

torsion spring will

automatically retract the lock pins when

the pressure on the lock pins is released.

a. Release the tractor brakes.

Failure to verify the area is clear of

others before moving the vehicle could

result in death or serious injury.

b. Gently rock the tractor and trailer fore and aft while

listening for the lock pins to disengage.

c. After the “metallic clang” of the lock pins disengaging

is heard, reset the tractor brakes, and visually verify

that the lock pins have been properly disengaged.

6. When the lock pins have disengaged – slowly reposition

the tractor until the slide box contacts the manual stop

bar (Figure 24).

7. a. Set the tractor brakes.

NOTE: Trailer parking brakes should still be engaged.

RELOCATED

MANUAL

STOP BAR

MANUAL

STOP BAR

PULL ARM

HANDLE

PULL ARM

HANDLE

DISENGAGED POSITION

NOTCH 1

NOTCH 2

LOCK PINS

DIS-ENGAGED

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

Saf-holland XL-AS11011OM CBX40/CB-4000 Slider Suspension Syste Manuel d'utilisateur Page 18

Commentaires sur ces manuels