Saf-holland XL-FW10054UM FWS1 and FWS2 Series Fifth Wheels Manuel d'utilisateur Page 15

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 24
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 14
15
XL-FW10054UM-en-US Rev B · 2012-03-09 · Amendments and errors reserved. © SAF-HOLLAND, Inc.
Figure 28
Figure 26
Figure 27
Figure 29
Maintenance Procedures
4$3*#&4&$0/%-*/&
4$3*#&'*345-*/&
'*'5)8)&&-
'30/5-0$,
13. Fifth Wheel Adjustment
Fifth wheel adjustment should be checked
at a minimum of every 60,000 miles or if
excessive movement between kingpin and
fifth wheel is noticed when driving the vehicle.
IMPORTANT: Excessive movement
between the tractor
and trailer can effect
vehicle handling.
Failure to maintain proper
fifth wheel adjustment
could result in loss of
vehicle control which, if
not avoided, could result
in death or serious injury.
NOTE: To obtain proper fifth wheel
adjustment SAF-HOLLAND
recommends use of Holland
lock tester Part No. 4000171,
available from your local
Holland distributor.
1. If fifth wheel is locked, lift release
handle up, pull all the way out, and up
again to hook on casting. If air release
equipped, actuate fifth wheel control
valve to open lock (Figure 26).
2. Ram lock tester into fifth wheel top
plate to lock fifth wheel (Figure 27).
3. Push the lock tester forward so that it
is tight against the fifth wheel’s front
lock. Ensure the lock tester is pressed
flat against the surface of the fifth
wheel. Scribe a line on the surface of
the fifth wheel face along front edge
of lock tester (Figure 28).
4. Pull lock tester toward fifth wheel ramps.
Ensure the lock tester is pressed flat
against the surface of the fifth wheel.
Scribe a second line on the surface of
the fifth wheel face along front edge
of lock tester (Figure 29).
Vue de la page 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Commentaires sur ces manuels

Pas de commentaire