Saf-holland XL-FW10054UM FWS1 and FWS2 Series Fifth Wheels Manuel d'utilisateur Page 14

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 24
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 13
14
XL-FW10054UM-en-US Rev B · 2012-03-09 · Amendments and errors reserved. © SAF-HOLLAND, Inc.
Maintenance Procedures
#"T/FFEFE-VCSJDBUJPO
t .BJOUBJOMVCSJDBUJPOPOGJGUI
wheel-to-trailer contact surfaces.
Use a water-resistant lithium-based
grease. Clean grease grooves if a
large amount of debris is present.
t $MFBOBOEMVCSJDBUFMPDLJOHNFDIBOJTN
if operational difficulties arise during
the service life of your fifth wheel
(i.e. problems with coupling, uncoupling,
or pulling the release handle).
12. Slide Base Lubrication
NOTE: Slide base should be moved fore
and aft at least once a year to
maintain optimum performance.
IMPORTANT: If equipped with air
release, lubricate air
cylinder every three (3)
months or 30,000 miles.
1. With the piston shaft in the exposed
position, clean with penetrating oil
and a clean shop towel (Figure 22).
(ILS sliders-spray spring covered piston
shaft thoroughly with penetrating oil
(Figure 22).
IMPORTANT: DO NOT use any abrasives
on the exposed shaft as
they could damage the
piston shaft
2. Remove supply air line and add 2-4
drops of air tool oil to cylinder through
the supply fitting. Reinstall supply air
line (Figures 23 & 24 Traditional
Sliders and Figure 25-ILS Sliders).
3. Activate and de-activate air cylinder
2-3 times to work air tool oil into
cylinder and onto piston and verify
proper operation.
Figure 22
53"%*5*0/"-4-*%&34
Figure 23
*-44-*%&3
Figure 25
Figure 24
*-44-*%&3
4611-:
'*55*/(
1*450/
4)"'5
1*450/
4)"'5
4611-:
'*55*/(
53"%*5*0/"-4-*%&3
4611-:'*55*/(
53"%*5*0/"-4-*%&3
Vue de la page 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Commentaires sur ces manuels

Pas de commentaire