Saf-holland XL-FW10009UM FW35 Series Fifth Wheel Manuel d'utilisateur Page 16

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 76
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 15
XL-FW10009UM-en-US Rev B · 2012-06-05 · Amendments and errors reserved. © SAF-HOLLAND, Inc.
16
Figure 32
Figure 34
Figure 31
Figure 33
Maintenance Procedures
PISTON
SHAFT
TRADITIONAL SLIDERS
PISTON
SHAFT
ILS SLIDER
SUPPLY FITTING
TRADITIONAL SLIDER
13. Slide Base Lubrication
NOTE: Slide base should be moved fore
and aft at least once a year to
maintain optimum performance.
IMPORTANT: If equipped with air
release, lubricate air
cylinder every three (3)
months or 30,000 miles
whichever comes first.
1. With the piston shaft in the exposed
position, clean with penetrating oil
and a clean shop towel (Figure 31).
ILS Sliders: Spray spring covered piston
shaft thoroughly with penetrating oil
(Figure 32).
IMPORTANT: DO NOT use any abrasives
on the exposed shaft as
they could damage the
piston shaft.
2 Remove supply air line and add 2-4 drops
of air tool oil to cylinder through the
supply fitting. Re-install supply air line
(Figures 33 and 34 - Traditional
Sliders, Figure 35 - ILS Sliders).
3. Activate and de-activate air cylinder
2-3 times to work air tool oil into
cylinder and onto piston and verify
proper operation.
14. Fifth Wheel Adjustment
Fifth wheel adjustment should be performed
at a minimum of every 60,000 miles or if
excessive movement between kingpin and
fifth wheel is noticed when driving the vehicle.
IMPORTANT: Excessive movement
between the tractor
and trailer can effect
vehicle handling.
TRADITIONAL SLIDER
SUPPLY FITTING
Vue de la page 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 75 76

Commentaires sur ces manuels

Pas de commentaire