Saf-holland XL-FW488 FW2800 and FW2900 Series Hydraulic Elevat Manuel d'utilisateur

FIFTH WHEELSXL-FW488 Rev AFIFTH WHEELTECHNOLOGYFW2800 and FW2900 SeriesHydraulic ElevatingFifth WheelInstallation, Operation, Maintenance Procedures a

10XL-FW488 Rev AFW2800-SX and FW2900-5X TWIN CYLINDER ELEVATING FIFTH WHEELPiping Diagram Parts ListAIR PIPINGFOR FIFTHWHEEL LOCKS TO FIFTH WHEEL TOP

XL-FW488 Rev A11FW2800-X, FW2900-X, FW2800-X-87 and FW2900-X-87 SINGLE CYLINDER ELEVATING FIFTH WHEELParts ExplosionHYDRAULIC CYLINDER PARTSBRONZEBUSH

12XL-FW488 Rev AFW2800-SX and FW2900-5X TWIN CYLINDER ELEVATING FIFTH WHEELParts ExplosionHYDRAULIC CYLINDER PARTSBRONZEBUSHINGVEEPACKINGRODSCRAPER563

XL-FW488 Rev A13XA-2801-AX-1 TOP PLATEParts ExplosionITEM PART NO. QTY DESCRIPTION14 XB-T-69-A 3 Lock Nut, 1/2˝-2015 XB-PW-1732-1-116 3 Washer, 1/2˝16

14XL-FW488 Rev AOPERATING PROCEDURESFailure to read, understand and follow the important informationcontained in these instructions may result in a ha

XL-FW488 Rev A15OPERATING PROCEDURES continued4. Set engine speed to 1000 to 1200 r.p.m. and operate control valve to lower thetrailer until it rests

CABLE IS LOOSE - TIGHTEN BY ROTATING TURNBUCKLECABLE IS TIGHT - NO ADJUSTMENT NEEDED16XL-FW488 Rev AOPERATING PROCEDURES continuedCoupling Procedures

XL-FW488 Rev A17

18XL-FW488 Rev A

XL-FW488 Rev A19WARRANTYWarrantyCOMMERCIALPRODUCTS WARRANTYHolland warrants all Commercial Products (productsother than those normally used for person

2XL-FW488 Rev AINSTALLATION INSTRUCTIONSWhen welding, use a procedure which assures a sound, good qualityweld and which protects the operator and othe

20XL-FW488 Rev AIMPORTANT: Enclosed is important information for the installation,operation, and maintenance of this product. Read andunderstand this

XL-FW488 Rev A3INSTALLATION INSTRUCTIONS continued6. The bolts attaching the fifth wheel mounting angles to the truck frame requirehardened steel wash

C. Take the marked angles and position them on the tractor frame.NOTE: The marked angles will no longer be symmetrical. It is critical to make certain

9. Remove the rear pivot shaft (see corresponding fifth wheel’s parts list — pages 11through 12 — in combination with Chart 2 — to find the rear pivot

6XL-FW488 Rev APOWER TAKE OFF (PTO) ANDHYDRAULIC PUMP INSTALLATIONGeneral Information1. Hydraulic fifth wheels require certain hydraulic components fo

XL-FW488 Rev A7POWER TAKE OFF (PTO) ANDHYDRAULIC PUMP INSTALLATION continuedHydraulic Component Installation continuedNOTE: Hose and fittings for thes

8XL-FW488 Rev APOWER TAKE OFF (PTO) ANDHYDRAULIC PUMP INSTALLATION continuedB. Fill the oil tank (approximately 5 gallons), taking precautions not to

XL-FW488 Rev A9FW2800-X and FW2900-X SINGLE CYLINDER ELEVATING FIFTH WHEELPiping Diagram Parts ListAIR PIPINGFOR FIFTHWHEEL LOCKS TO FIFTH WHEEL TOP P